Impregnator with Wet Effect- DOLPHIN SM, 10l

Purpose: used to protect the ceramic (clinker), brick, concrete, plaster, stucco surfaces, natural stone, marble, slate, ceramic tiles, thus forming a hydrophobic coating. It promotes the continuation of the life of the base, a substantial decrease in the formation of mold and mildew, sensitivity to freeze-thaw cycles, reduce the heat. The treated surface is resistant to cleaning agents, greatly facilitates the removal of dirt and stains. The tool gives the surface a little gloss and saturation of colors, surfaces become more attractive. For interior and exterior use! Environmentally friendly product!

Composition: aqueous emulsion of acrylic copolymers with silicone additives.

Properties has a high coefficient of adhesion (excellent adhesion to the surface). It forms a coating resistant to the effect of precipitation and temperature changes.

Colour Emulsion: milky.

Surface preparation: the treated surface to remove dirt, dust and particle tight, clean from grease and oil.

Use: Apply by brush, spray, roller until full saturation of the surface. Apply at temperatures above + 5 ° C, as a means of water-based.

Drying time at + 20 ° C and 65% relative humidity for 30 minutes to 1 hour.

Consumption: about 50 - 150 g / m² depending on the porosity of the surface.

Specifications:

1) film appearance: homogeneous, without extraneous inclusions;

2) Mass fraction of solids,%, not less than 10;

3) the relative viscosity by viscometer VZ - 246 with 4 mm diameter nozzle at a temperature of

(20 ± 2) ° C, 7 - 12;

4) Drying time to degree 3 at (20 ± 2) ° C, minutes: no more than 60.

Volume: 10 l.

Storage: Store in tightly closed containers at temperatures between + 5 ° C to + 25 ° C.