Impregnator with a "wet" effect DOLPHIN Sm
Impregnation - Premium hydrophobizing agent for natural and artificial stone, as well as any mineral surfaces with a damp wet effect and the effect of strengthening the porous material on a latex basis.
Appointment: It is used to protect ceramic, clinker, brick, concrete, gypsum, plastered surfaces, natural and artificial stone, marble, slate, ceramic tiles, wood products, forming a hydrophobic coating. Helps to extend the life of the base. Partially strengthens porous mineral surfaces, preventing them from exfoliating and breaking down. Prevents the formation of fungus and mold. Reduces sensitivity to freeze-thaw cycles, as well as the heat transfer of the material. The treated surface is resistant to detergents, prevents the formation of efflorescence, greatly facilitates the elimination of dirt and stains. The tool gives the surfaces a saturated color without the formation of a film, creating the so-called matte wet effect. Suitable for both vertical, and horizontal surfaces. It has a long service life due to the use of high-quality organosilicon compounds of the latest generation.
Suitable for outdoor and indoor use! Environmentally friendly product!
Composition: aqueous emulsion of latex copolymers with organosilicon and fungicidal additives.
Properties: has a high adhesion coefficient (excellent adhesion to the surface). It forms a coating resistant to atmospheric precipitation and temperature difference.
Surface preparation: remove dirt, dust and loose particles from the treated surface, clean from grease and oil.
Method of use: Before use, mix thoroughly (shake) in a container with the product or separately. Apply with a brush, sponge or spray until the surface is completely saturated, or with 2 layers, wet on wet. Apply a thin layer, carefully rubbing large white drops on the surface so that there are no smudges. Apply at a temperature not lower than + 5 ° C, since the product is water-based. Allow the common layer to polymerize (stand) for at least 24 hours after application, without exposure to moisture (oblique rain) on the surface.
Drying time: at a temperature of + 20 ° C and humidity not more than 65% from 30 minutes to 1 hour.
Consumption: approximately 50 - 250 g / m² depending on surface porosity.
Packing: 1.00; 5.00; 10.00 l
Storage: store in a tightly closed container at a temperature of + 5 ° C to + 25 ° C.
Link to product video:
FEM pavers impregnation