Impregnation Dolphin ECO 10l.

312074257_w640_h640_209471006_w640__0_delphinc-5

1,200₴

Purpose: it is used to protect ceramic, clinker, brick, concrete, gypsum, plastered surfaces, natural stone surfaces, marble, slate, ceramic tiles, thus forming a hydrophobic coating. It contributes to the continuation of the life of the base, a significant reduction in the formation of fungi and mold, sensitivity to freeze-thaw cycles, a decrease in heat transfer. The treated surface is resistant to detergents, greatly facilitating the removal of dirt and stains. The agent practically does not change the color of the surface. Suitable for indoor and outdoor work. Environmentally friendly product!

Composition: aqueous emulsion of acrylic copolymers with organosilicon compounds, biocide.

Properties: has a high adhesion coefficient (excellent adhesion to the surface). Forms a coating that is resistant to the effects of precipitation and temperature changes.

Emulsion color: milky.

Surface preparation: remove dirt, dust and loose particles from the surface to be treated, and remove grease and oil.

Method of use: apply with a brush, spray gun, roller until full saturation of the surface. Apply at a temperature of at least + 5 ° C, since the product is water-based.

Drying time: at a temperature of + 20 ° С and humidity of air of 65% from 30 minutes to 1 hour.

Consumption: approximately 50 - 150 g / m² depending on the porosity of the surface.

Specifications:

1) film appearance: homogeneous, without extraneous inclusions;

2) mass fraction of non-volatile substances,%, not less than: 10;

3) conditional viscosity according to the viscosimeter VZ-246 with a nozzle diameter of 4 mm at temperature

(20 ± 2) ° С, with: 7 - 12;

4) Drying time to grade 3 at (20 ± 2) ° C, min: not more than 60.

Packing: plastic canister 10 liters.

Storage: Store in a tightly closed container at a temperature between + 5 ° C and + 25 ° C. In case of prolonged storage, periodically open the lid of the canister (if it swells) to release air, due to the peculiarities of the expansion of the gases released by the coating.

Manufacturer
PC SVOY DOM, UKRAINE